The self-service car wash is a self-made method of creating a modest and cheap way of cleaning the car. It is a practical approach for giving a vehicle full cleaning services. It is found that most of the self-service stations are reasonably comparable and straightforward to utilize. If someone arrives at the station with enough money, just as a fundamental understanding of the different settings of self-service station, one can have the option to give the vehicle a profound clean for a few dollars not exactly automatic stations while overseeing the nature of the cleaning.
There are various steps if followed; then one can easily make it possible for its vehicle to wash it at home.
Parking the car in an empty bay. An empty bay is an area where the car is parked in a self-service station. The vehicle should be parked in the center of the bay. After parking, it is making sure that there is enough space to walk around the car. It means that adjusting its parking before washing it.
Removing the floor mats from the interior of the car.
If the floor rugs are made up of plastic or rubber, then it is necessary to make those rugs out of the car and fix them against the wall so that it will be easy to make it clean them with the spray wand. This step can be skipped if mats are already made of carpet. Finding the Spray Wand.
The spray wand is usually attached to a stand inside the bay.
It is advised to pick up the rod in order to make sure it can reach around the car. If there is any trouble having reaching certain areas, then readjustment is necessary to make in the parking job. For using the spray wand, it is essential to point the tip away from and gently press the handle beneath the nozzle. Doing this, it discharges a pressurized stream of water. It is recommended that standing close to the spray wand is dangerous and its high pressure can also damage the car, so it is necessary to take precautionary measures of spray wind before using it. If you stand too close, the high-pressure stream can result in and damage to your vehicle.
Also check : Top Fastest Cars in the World
Similarly, you should avoid shooting the higher pressure spray into the engine bay directly.
Familiarize with the sprayer settings. Most of the machines of a self-wash offer between three to five different spray settings that are used for a through leaning. So it is necessary to check out the computer to find out which parameters are available and to know how much of time it takes to allocate for each environment.
Most of the necessary machines include three of settings washing, putting soap on it, and rinsing it.
Insert money into the machine. The Self-service car washes, the time is set, and the amount of the money inserted corresponds with the length of time in which the car is being washed. The timing of car wash starts immediately after inserting money, so it is required to be ready quickly.
Most of the self-service car wash costs between $2-5, but it depends on the state of the car.
If in case the machines don’t mention the amount of money required for a specific time than one can start it with the smaller amount.it is also necessary to know that what type of payments will that machine accept. And finally, rinse the car with a spray wand.
By rinsing the car, it is advised to take one complete lap around the vehicle, after that spray down the entire vehicle to remove the superficial dirt on it.
Wash the car from top to bottom. Washing the car from top to bottom will help the dirty run-off water completely Applying the soap in car with the spray wand. For using the soap, turn on the dial on the machine. On the spray wand, when the handle is pulled, a soapy stream will start spraying from the rod.
Use Spray Wand to Clean the Foam.
After applying soap to the car, exchange the spray wand for the foam brush, that can is located in a container near the service machine. To do so, it is necessary to change the settings on the computer from soap so that it can easily be rinsed, then use the spray wand to clean the bristles of the brush. Scrub the car with the foam brush. For scrubbing, it is necessary to hold the brush by handles and use the bristles to lather the soap into the body of the car to give it a thorough clean.
Clean the Car and Dry it.
Four things are needed to be done for rinsing and drying the vehicle. The first thing is to use the spray wand so that studs from the vehicle will be cleaned easily. Second is to wax it. The third is to return the spray wand at the station. The last thing to do is to Dry the floor mats. Conclusion Self-servicing your car is an easy job once you get a hold of it. Make sure you understand how it works.
Then, you and your car can have a great time.